Table of Contents
Advertisement
Part Names and Functions
Remote Control Code
This projector has eight different remote control codes (Code 1-Code 8). Switching remote control codes prevents remote
control interference when operating several projectors or video equipment at the same time. Change the remote control
code for the projector first before changing that for the remote control. See "Remote control" in Setting on page 46.
1
With holding down the MENU button, press the IMAGE
button. The code switches sequentially for one pressing the
IMAGE button. (See the list below.)
2
To initialize the remote control code, slide the
RESET/ON/ALL-OFF switch to RESET, and then to ON. The
initial code is Code 1. (p11)
Remote Control Code
Code 1
Code 2
Code 3
Code 4
Code 5
Code 6
Code 7
Code 8
Remote Control Battery Installation
Remove the battery
1
compartment lid.
Press the lid downward
and slide it.
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or LR6 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture, or heat.
● Do not drop the remote control.
● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
14
Number of Times of
Pressing IMAGE Button
1
2
3
4
5
6
7
8
Slide the batteries into
2
the compartment.
Replace the compartment
3
lid.
Two AA size batteries
For correct polarity (+ and
–),
be
sure
battery
terminals are in contact
with pins in compartment.
IMAGE button
While pressing the MENU
button, press the IMAGE
button
number
of
times
corresponding to the remote
control code.
MENU button
Advertisement
Table of Contents
