Setting Up The Stack Projection - Eiki EIP-5000L Setup Manual

Setting up the Stack Projection

Basic
This part shows an example for setting up the stack projection of a computer image with two projectors.
Projector 1: Master
Projector 2: Slave
1
Set the "Stack Setting" of the pro-
jector 1 to "Master".
(See page 84 on the owner's manual of the
projector.)
2
Set the "Stack Setting" of the pro-
jector 2 to "Slave".
(See page 84 on the owner's manual of the
projector.)
3
Perform "Pair Stack" of the both
projectors.
(See page 85 on the owner's manual of the
projector.)
INPUT 1 terminal
INPUT 1 terminal
RGB cable
OUTPUT (FOR INPUT 1, 2)
terminal
LAN terminal
RGB
LAN cable
cable
(cross-over type)
LAN terminal
4
Select inputs as specified in the
table below.
(See page 86 on the owner's manual of the
projector.)
Projector 1
Master
Set Inputs
INPUT1
ON
INPUT2
OFF
INPUT3
OFF
INPUT4
OFF
INPUT5
OFF
5
Turn off the both projectors.
Stack Projection
Computer
Projector 2
Slave
Set Inputs
INPUT1
ON
INPUT2
OFF
INPUT3
OFF
INPUT4
OFF
INPUT5
OFF
39