HP Vectra VEC 7 Installation Manual page 40

4 Connecting to a Windows NT Server 4.0
Windows NT Workstation 4.0
8 Power on the machine and allow it to boot to Windows NT Workstation 4.0.
9 Log onto the machine with administrator privileges. (If you do not have the
required information, contact your network administrator.)
10 Click on "Start" and move to "Settings", open the "Control Panel" group
and double-click the "Network" icon.
11 Click on "Yes" and agree to install "Windows NT Networking."
12 With "Wired to the Network" checked, click on "Next."
13 Click on the option to "Select from list" then on "Have Disk."
14 Insert the 3COM 3C590 drivers disk into the floppy drive.
15 With the path set to "A:\NDIS\WINT35\", click "OK."
(If you have a Hewlett-Packard pre-loaded HDD, set the path statement
to "C:\MASTERS\LANDRV\3C590\NDIS\WINNT35\")
16 Select "3Com Etherlink III PCI Bus-Master Adapter (3C590 )" and click "OK."
17 With "3Com Etherlink III PCI Bus-Master Adapter (3C590 )" listed in the
"Network Adapters" window, click on "NEXT."
18 Select the applicable network protocols and click on "Next."
(If you do not have the required information, contact your network
administrator)
19 At the "Network Services:" prompt, accept default settings and click on "Next."
20 Finish the network card installation by clicking on "Next."
21 Designate the path to your NT files and select "Continue."
(If you have a Hewlett-Packard pre-loaded HDD, set the path to "C:\I386")
22 Select whether to use "DHCP Configuration" or to specify your IP address
and continue.
(If you do not have the required information, contact your network
administrator.)
23 At the "Show Bindings for:" prompt, accept default settings and click on "Next."
24 When "Windows NT is now ready to start the network..." click on "Next."
25 Specify your Computer Name, Workgroup or Domain and click on "Next."
(If you do not have the required information, contact your network
administrator.)
26 After "Network has been installed on this computer" click on "Finish."