HP Vectra VEC 7 Installation Manual page 25

Windows NT Requirements
Workstation 4.0
• HP Vectra with Windows NT Workstation 4.0 installed.
• 3COM Etherlink 3C590 PCI ethernet card and drivers disk ver 5.1a.
• Driver Name: El59X.SYS Size: 38KB Date: 1/27/97
• Microsoft Windows NT Workstation 4.0 and service pack media.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
I/O Port Address
Interrupt Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C590 PCI
2 Connect network media to the 3COM 3C590 PCI card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Etherlink 3C590 Ethernet card and drivers
5 Select "CONFIGURE NIC," and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3Com cards driver diskette and reboot the machine.
(If you have a Hewlett-Packard pre-loaded HDD, the media is located at
"C:\I386")
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Vectra VL8
FCC0h (PCI)
10 (PCI)
adapter card into a PCI slot.
disk ver. 5.2.1. and execute "A:\3C59XCFG.EXE."
under the heading "Device Configuration."
3 Connecting to a Windows NT Server 3.51
Normal
Disabled
Disabled
10BASE-T
Vectra VL7 Vectra VE7/VE8
FCC0h (PCI) DC00h (PCI)
10 (PCI) 10 (PCI)
Windows NT Workstation 4.0