HP Vectra VEC 7 Installation Manual page 3

1 Connecting to a Netware 3.12 Server
Windows for Requirements
Workgroups
• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.1A.
• DOS and MS-Windows for Workgroups 3.11 media.
• Novell Netware server 3.12 that supports Net BEUI, NWLink IPX/SPX,
• Netware client for DOS and MS-Windows.
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
I/O Base Address
Interrupt Request
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C509-B
2 Power on the machine and allow it to boot to a DOS prompt.
3 Insert the 3COM drivers diskette (ver. 5.0 downloaded from 3COM's
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
DOS ODI - File Name: EL59X.DOS Size: 27KB Date: 10/04/96
and NWLink NetBIOS transfer protocols.
Vectra VL8
FCCO (PCI)
10 (PCI)
Level
adapter card into an ISA slot.
website) and execute 3C59XCFG.EXE.
under the heading "Device Configuration."
1 Connecting to a Netware 3.12 Server
Normal
Disabled
Disabled
10BASE-T
Vectra VL7 Vectra VE7/VE8
FCC0h (PCI) DC00h (PCI)
9 (PCI) 10 (PCI)
Windows for Workgroups