HP Vectra VEC 7 Installation Manual page 4

1 Connecting to a Netware 3.12 Server
Windows for Workgroups
6 Remove the 3com cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
If you are using a Vectra VL7 or VE7/VE8, follow the instructions below to
complete the installation. If you are using a VL8, go directly to step 7.
a Execute INSTALL.EXE.
b Specify the settings as listed below:
• C:\NWCLIENT
• Yes
• Yes
• C:\WINDOWS
• No
• 3Com Fast Etherlink/Etherlink III Bus Master
c Under the heading "Select the driver for your network board", insert
the 3Com 3C590 drivers disk and set the path to "A:\NETWARE\
CLIENT." (If you have an HP preloaded HDD, set path to "C:\Masters\
LanDrv\3C590\NETWARE\CLIENT\)
d Press "Enter" to continue the installation.
e When prompted, insert the corresponding disks to complete file trans-
fer and driver installation.
f When the install utility is finished, press <CRTL><ALT><DEL> to
restart the machine.
g After Windows loads, open the "NETWORK" folder, double-click the
"NETWORK SETUP" icon.
h Select "Networks" and verify that "Novell Netware (Workstation Shell
4.0 and above)" is selected under "Install Windows support for the
following network only:"
i Select "OK" twice, and the installation is complete.
7 Execute INST_DOS.EXE and enter Yes to accept the agreement.
8 Accept the default products by pressing Enter, and then press "F10" to
continue.
9 Select 16-bit LAN Drivers and hit the Enter key.
10 Page down the Board Drivers list to "USER SPECIFIED 16 BIT DRIVER"