HP Vectra VEC 7 Installation Manual page 21

Windows NT Requirements
Workstation
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
Version 3.51
• 3COM Etherlink 3C590 PCI ethernet card and drivers disk ver. 5.1a.
• Driver Name: El59X.SYS Size: 38KB Date: 1/27/97
• Microsoft Windows NT Workstation 3.51 and Service Pack media.
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
I/O Port Address
Interrupt Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink III 3C590 PCI
2 Connect network cable media to the 3COM 3C590 card.
3 Insert a DOS bootable diskette and power on the machine.
4 After booting, insert the 3COM Software "3C590 PCI Ethernet drivers disk
5 Select "CONFIGURE NIC", and verify the resource settings listed above
6 If changes are required, save those changes and exit.
7 Remove the 3com Software driver diskette and reboot the machine.
8 After Windows loads, log onto the machine with administrator privileges.
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Vectra VL8
FCC0h (PCI)
10 (PCI)
adapter card into a PCI slot.
ver. 5.1a", execute "A:\3C59XCFG.EXE."
under the heading "Device Configuration."
3 Connecting to a Windows NT Server 3.51
Windows NT Workstation Version 3.51
Normal
Disabled
Disabled
10BASE-T
Vectra VL7 Vectra VE7/VE8
FCC0h (PCI) DCC0h (PCI)
9 (PCI) 10 (PCI)