HP Vectra VEC 7 Installation Manual page 13

Windows 95 SR2 Requirements
• HP Vectra with Windows 95 SR2 installed.
• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.1a.
• Vectra VE7/VE8 Driver: Windows 95 Embedded
• Windows 95 SR2 media. (If you have an HP preloaded HDD, the media is
• Novell Netrware 4.11 server that supports Net BEUI, NWLink IPX/SPX,
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
I/O Base Address
Interrupt Request
Procedure
1 With the HP Vectra turned off install the 3COM Etherlink III 3C590
2 Power on the machine and restart Windows 95 SR2 in MS-DOS Mode.
3 Insert the 3COM drivers diskette and execute "A:\3C59XCFG.EXE."
4 Select "CONFIGURE NIC," and verify the resource settings listed above
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and restart the machine.
7 Windows 95 SR2 should automatically recognize the 3COM 3C590
Vectra VL8 and VL7 Driver Name: EL59X.VXD Size: 38KB Date: 1/07/97
located at C:\Masters\Win95\System\Cabs\)
and NWLink NetBIOS transfer protocols.
Vectra VL8
FCC0h (PCI)
10 (PCI)
Level
adapter card into a PCI slot.
under the heading "Device Configuration."
ethernet card.
2 Connecting to a Netware 4.11 Server
Normal
Disabled
Disabled
10BASE-T
Vectra VL7 Vectra VE7/VE8
FCE0h (PCI) DC00h (PCI)
9 (PCI) 10 (PCI)
Windows 95 SR2