Unable To Specify Desired Settings Or Unable To Send As Specified; Error Message - Konica Minolta bizhub 601 User Manual

Troubleshooting
4.2

Unable to specify desired settings or unable to send as specified

Perform these troubleshooting procedures if settings cannot be specified in the fax driver or if the fax is not
sent as specified.
Note
Some of the fax driver functions cannot be combined with other functions.
Symptom
A fax driver setting cannot
be selected.
The "Conflicts" message
with "Unable to Select" or
"Function Canceled" ap-
pears.
The fax is not sent as spec-
ified.
The watermark cannot be
attached.
4.2.1

Error message

Message
Cannot connect to the net-
work.
Fax Driver
Probable cause
Some functions cannot be combined.
An incorrect combination of functions has
been specified.
Incorrect settings are specified.
A combination of functions, although
possible in the fax driver, is not possible
with this machine.
The paper size, orientation, and other set-
tings specified in the application have pri-
ority over those specified in the fax driver.
The watermark is not correctly set.
The watermark density is set to a level
that is too low.
Watermarks cannot be outputed in
graphics applications.
Cause and remedy
A connection to the network could not be established.
Check if the network cable is correctly connected. In addition, check that the Net-
work Setting parameters on the Administrator Setting screen have been correctly
specified.
Action
Do not try to select settings that are not
available.
Check the settings and specify the func-
tions correctly.
Check each setting in the fax driver.
Enter the correct settings in the applica-
tion.
Check the watermark settings.
Check the density settings.
No watermark can be outputed in this
case.
4
4-3