Setup Procedure - Panasonic TY-TP50P10S - Touch-screen - Wired Operating Instructions Manual

Setup Procedure

1
Install the Driver Software
Do not connect the USB cable yet.
2
Connect the touch panel and computer
3
Restart your computer
• After restarting your computer, check
• If the icon does not appear, if it appears with an X over it or if an error message is displayed,
see "Before Calling for Service" (p. 40) and "Error Messages". (p. 42)
4
Calibrate the touch panel
This completes the basic setup.
■
Driver Software Operating Environment
The Driver software is supported by both the Japanese and English versions of Windows 2000 (SP4 or
later), Windows XP (SP1 or later) and Windows Vista (32-bit only).
* Windows is a registered trademark of Microsoft Corporation in the USA and other countries.
The following environment is required to correctly install and start up the Driver software.
<Windows 2000 or Windows XP>
• CPU ... Pentium III or later (2 GHz or faster Celeron or Pentium 4 recommended)
• Memory ... 512 Mbytes or more
• HDD ... 30 Mbytes or more available area
• Compatible with USB 1.1/2.0 interface
■
Driver Software Restrictions
• The mouse emulation feature cannot be used on the login window that appears at Windows startup, when
restoring from the suspended state or when the screen saver is unlocked. The mouse emulation feature is
activated after you log in.
• There is no remote wakeup feature that activates the screen from the suspended state by touching the
touch panel.
• If your system does not meet the requirements above or the applications use up too much memory, the
response of the touch panel may slow down.
• Only Windows is supported. (Operation is not guaranteed in other environments than the above.)
• If using Windows Vista and user account control, the touch panel does not respond to touch when
windows, such as the Properties window, that require administrator authority to access appear.
■
Restrictions on competing drivers
• If you try to install a driver from another manufacturer in the same computer in which this Driver software
is installed or inversely try installing this Driver software in a computer where another driver is already
installed, the driver may not install properly.
In such case, uninstall the current driver and then install the new driver.
Also, if a driver from another manufacturer is started up while this Driver software is already running, the
error message "A driver is already running." may be displayed.
In such case, quit both drivers and then start up the driver you want to use.
appears in the task tray.
P. 14
P. 16
P. 27
13