GE GSD4000NBB - Full Console Dishwasher Owner's Manual page 14

Owners manual
Hide thumbs Also See for GSD4000NBB - Full Console Dishwasher:
Table of Contents

Advertisement

Before you call for service...
Problem
Possible Causes
What To Do
Dishes don't dry
Low inlet water
o Make sure inlet water temperature is at least 120°K
temperature
_ Select HEATEDDRY.
Use HOTSTART and ADDEDHEAToptions.
Select a higher cgcle, such as POTS& PANSor HEAVYWASH.
Rinse agent dispenser
_ Check the rinse agent dispenser and fill as required.
is ernptg
Dishes end flatware
inlet water temperature
_ Raisethe water heater temperature to 120°R
not cleon
is below 120_F.
_ Use HOTSTART, POTS& PANSor HEAW WASHand HI TEMPWASH.
Too little detergent
• See Using the dishwasher section, refer to Proper Useof Detergent for
detergent recommendations.
Old or damp powdered
* See Using the dishwasher section, refer to Proper Useof Detergent for
detergent
detergent recommendations.
Water pressure is
• Turn on a faucet. Is water coming out more slowlg than usual?if so,
temporarilg low
wait until pressure is normal before using gour dishwasher
Air gap is clogged
o Clean the air gap.
improper rack loading
o Hake sure large dishware does not block detergent dispenser or wash arm.
No air gap or high
o Verifg that gou have an air gap or a high drain loop. Referto
drain loop
the Installation Instructions.
Spots and filming
on glasses and
flatware
Extremelg hard water
Low inlet water
temperature
Overloading the
dishwasher
Improper loading
Old or damp powder
detergent
Rinse agent dispenser
emptg
Too little detergent
Use Jet-Dry _ or Cascade Crystal C'/eor _ rinse agents to remove spots
and prevent new film buildup.
To remove stubborn spots and pre-existing film from glassware:
1 Remove all metal utensils from the dishwasher.
2 Do not add detergent.
3 Select the longest cgcle.
4 Start the dishwasher and allow to run for 18 to 22 minutes.
Dishwasher will now be in the main wash.
5 Open the door and pour 2 cups (500 ml) of white vinegar into the
bottom of the dishwasher.
6 Closethe door and allow to complete the cgcle. If vinegar rinse
doesn't work: Repeat as above, except use 1/4 cup (60 ml)of citric
acid crgstals instead of vinegar
14
Cloudiness on
Combination of soft
* This is called etching and is permanent. To prevent this from
glassware
water and too much
happening, use less detergent if gou have soft water. Wash glassware in
detergent
the shortest cgcle that will get it clean.
Water temperature
_ Lower the water heater temperature.
entering the dishwasher
exceeds 150"R
Detergent cup lid
Dial is not in the OFF
, Turn the Timer Dia! to OFF.
won't latch
position
Detergentleft in
Dishes are blocking the
_ Reposition the dishes.
dispenser cups
detergent cups
Steam
This is normal
• Steam comes through the vent bg the door latch during drging and
when water is being pumped out.
Black orgroy
Aluminum utensils have • Remove marks with a mild, abrasive cleaner.
marks on dishes
rubbed against dishes
Control pond lights
Time too long between
* Each pad must be touched within 30 seconds of the others. To relight,
go offwhen you ore
touching or selecting
touch ang pad again or unlatch and relatch the door.
setting controls
pads
Control panel
Door latch rnag not
_ Callfor service.
responded to inputs
be propedg seated
but dishwasher never
filled with water

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents