Table of Contents Table of Contents English ...................... 1. Before You Start ................. 2. Hardware Installation ................. Configure the Wireless Router ............Troubleshooting ..................Version 07.06.2006...
1. Before You Start Package Contents TEW-631BRP Quick Installation Guide User's Guide CD-ROM 1 x 4dBi Detachable Antenna 1 x RJ-45 Ethernet Cable (Yellow) Power Adapter (5V, 2.5A) Installation Requirements A computer with a wired or wireless network adapter properly installed.
TEW-631BRP's WAN port. Connect the other end of the cable to your modem. 4. Connect the AC Power Adapter to the TEW-631BRP and then to a power outlet. 5. Verify that the following panel lights are on: Power, LAN, WAN and WLAN.
3. Configure the Wireless Router Note: It is recommended that you configure the Wireless Router from a wired computer. 1. Open your web browser, type http://192.168.1.1 in the Address bar, and press Enter. 2. Enter the User Name and Password, and then click Log In. User Name: Admin By default, there is no password.
Page 6
Then click Next. 8. Click Reboot the Device. 9. Click OK. Your installation is now complete. For detailed information regarding the TEW-631BRP's configuration and advanced settings, please refer to the Troubleshooting section, User's Guide CD-ROM, or TRENDnet's website at http://www.trendnet.com. English...
I typed http://192.168.1.1 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TEW-631BRP's web configuration page? First, check your hardware settings again by following the instructions in Section 2.
Page 8
Second, double check that the WLAN light on the Router is lit. Third, power cycle the TEW-631BRP. Unplug the power to the TEW-631BRP. Wait 15 seconds, then plug the power back in to the TEW-631BRP. Fourth, log into the TEW-631BRP (see Section 3). Click on Basic and then Wireless. Make sure Enable Wireless is checked.
Page 9
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.