Table of Contents Table of Contents English ... 1. Before You Start 2. Install Router ... 3. Adding the router behind an existing 192.168.1.x network ... Troubleshooting ... Version 03.27.2006...
1. Verify that you have a direct connection from your Cable or DSL modem to your computer. Also verify that you are connected to the Internet by browsing to a website, such as http://www.trendnet.com. Internet Package Contents TEW-631BRP Easy Go CD-ROM...
2. Install Router 1. Insert the Easy Go CD-ROM in your computer's CD-ROM Drive and then click Install Router. 2. Click Start Installation. 3. Choose the desired language from the dropdown list and then click Next. 4. Click Next. English...
Page 5
5. If this screen appears, go to Section 3. If not, please continue to step 6. 6. Follow the Wizard instructions and continue through the remaining installation steps. Click Next. 7. When the Wireless Network screen appears, make sure you enter a unique network name and then click Next.
Page 6
Exit Router Setup and then click Finish. Your installation is now complete. For detailed information regarding the TEW-631BRP configuration and advanced settings, please refer to the User's Guide included on the Easy Go Installation CD-ROM or TRENDnet's website at www.trendnet.com.
Note: When this window appears, it means you have a DSL/Cable modem or router that's running the 192.168.1.x network. If you are replacing your current router with the TEW-631BRP, please select yes and click Next to continue. If you are adding this router behind the DSL/Cable modem, please select no and click Next to continue.
Page 8
Router. Please refer to the Troubleshooting section for instructions. Your installation is now complete. For detailed information regarding the TEW-631BRP configuration and advanced settings, please refer to the User's Guide included on the Easy Go Installation CD-ROM or TRENDnet's website at www.trendnet.com.
First, make sure that the WLAN switch on the back of the router is set to on. Second, double check that the WLAN light on the Router is lit. Third, power cycle the TEW-631BRP. Unplug the power to the TEW-631BRP. Wait 15 seconds, then plug the power back in to the TEW-631BRP. Fourth, contact the manufacturer of your wireless network adapter and make sure the wireless network adapter is configured with the proper SSID.
Page 10
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation.