Configuring Wireless Multi-Point Bridging - NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual

Configuring Wireless Multi-Point Bridging

In this mode, the WG602 will communicate with up to four bridge-mode wireless access points by
entering the MAC address (physical address) of each of the bridge-mode APs in the fields
provided. In addition, if you check the Enable Wireless Client Association checkbox, wireless
clients will also be serviced by this access point. Each wireless access point you enter will be listed
in the Wireless Remote Access Point List.
To configure wireless Multi-point Bridging:
1. Open a web browser and log into the WG602v3 using the addressing scheme you have set up.
Figure 4-3
4-4 Advanced Configuration
v1.0, August 2006