NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual page 58

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
3. Check the Client Mode radio box.
• DHCP Client will be disabled.
• The default IP Address and IP Subnet Mask will be enabled.
Reconfigure these settings if appropriate.
4. Click Apply and click OK when the Reboot warning message appears. The system will reboot
and display the Information screen showing that Client Mode has now been enabled as the
Access Point Mode.
Figure 4-8
The Associated AP field indicates whether or not the WG602v3 has connected to a remote AP
by displaying the MAC address of the connected access point.
To modify the Client Mode Wireless Settings or to connect to another AP:
1. From under the Setup menu, select Wireless Settings. The Wireless Settings screen will
display with a banner noting that the wireless access point is running in Client Mode.
4-10
v1.0, August 2006
Advanced Configuration