NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual page 53

2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen
will display showing the default settings for the wireless access point.
3. Select the Wireless Multi-Point Bridging radio button to enable multi-point bridging.
4. Enter the MAC address of the first wireless access point and click Add. The AP's MAC
address and connection information will appear in the Wireless Accept Point List.
You can add wireless access points to the list for a total of four. (These wireless access points
must be configured for Multi-Point Bridging.)
5. Check the Enable Wireless Client Association radio box to allow wireless clients access to
this wireless access point.
6. Click Apply to save your changes.
To delete a remote AP from the list, click Delete adjacent to the AP's MAC address in the Wireless
Remote Access Point List.
The following figure illustrates a multi-point bridge setup over three LAN segments.
Wireless PC Card
in a Notebook Computer
Router
Internet
192.168.0.1
LAN
Segment 1
Figure 4-4
To configure wireless access points in a multi-point configuration:
1. Set the Operating Mode of the three Wireless APs as follows:
• Configure AP2 on LAN Segment 1 in Point-to-Point Bridge Mode. Enable Wireless Client
Association and add the Remote MAC Address of AP1 on LAN Segment 2.
Advanced Configuration
NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
AP2
Point-to-Point
Bridge Mode
PCs
v1.0, August 2006
AP1
Multi-Point
Bridge Mode
Hub or Switch
LAN
Segment 2
PCs
AP3
Point-to-Point
Bridge Mode
Hub or Switch
LAN
PCs
Segment 3
4-5