NETGEAR WG602 - 54 Mbps Wireless Access Point Reference Manual page 50

NETGEAR 54 Mbps Wireless Access Point WG602v3 Reference Manual
For each remote wireless access point MAC address that you add, the WG602 must validate that
the SSID, channel, and WEP configuration of the each remote access point match the settings of
this WG602. WEP can (and should) be used to protect this traffic.
To configure a point-to-point bridge:
1. Open a web browser and log into the WG602v3 using the addressing scheme you have set up.
Figure 4-1
2. Under Advanced on the main menu, click Wireless Bridging. The Wireless Bridging screen
will display showing the default settings for the wireless access point.
3. Select the Wireless Point-to-Point Bridging radio button to enable point-to-point bridging
and enter the MAC address of the Remote Access Point.
4. Check the Enable Wireless Client Association to allow wireless clients access to the wireless
access point.
4-2
v1.0, August 2006
Advanced Configuration