D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual page 107

1. Configure WPA/WPA2 Personal (PSK) security on each client as follows.
2. Configure the following settings on the Association tab on the Network Properties dialog.
Network Authentication
Data Encryption
Network Key
The key is provided for me
automatically
3. Configure the following settings on the Authentication tab on the Network Properties
dialog.
Enable IEEE 802.1X
authentication for this
network
4. Click OK on the Wireless Network Properties dialog to close it and save your changes.
WPA-PSK clients should now be able to associate and authenticate with the access point. As a
client, you will not be prompted for a key. The TKIP or AES key you configured on the client
security settings is automatically used when you connect.
A Wireless Client Settings and RADIUS Server Setup
WPA-PSK
TKIP or AES depending on how this option is configured on the
access point.
Note: When the Cipher Suite on the access point is set to "Both", then
TKIP clients with a valid TKIP key and AES clients with a valid
CCMP (AES) key can associate with the access point.
Provide the key you entered on the access point Security settings for
the cipher suite you are using.
For example, if the key on the access point is set to use a TKIP key of
"012345678", then a TKIP client specify this same string as the
network key.
This box should be disabled automatically based on other settings.
Make sure that IEEE 802.1X authentication is disabled (unchecked).
(Setting the encryption mode to WEP should automatically disable
authentication.)
Configuring WPA/WPA2 Personal on a Client
Choose WPA-PSK
Choose either TKIP or AES for
the Data Encryption mode
Enter a network key that matches
the one specified on the access
point (and confirm by re-typing)
107