D-Link DWL-3500AP - AirPremier Wireless Switching 108G Access Point Administrator's Manual page 140

D-Link Unified Access Point Administrator's Guide
Table 39. VAP Commands
Action
Get the current security mode
Get detailed description of current
security settings
Set security to plain text
Set security to static WEP
Set security to IEEE 802.1X
Set security to WPA/WPA2
Personal (PSK)
Set security to WPA/WPA2
Enterprise (RADIUS)
Set Security to Static WEP
To configure Static WEP as the security mode, you need to issue multiple commands. This
section describes the commands and procedures to configure Static WEP.
NOTE: This example shows how to configure static WEP on VAP 0 on radio 1
1. Set the security mode.
DLINK-AP#
2. Set the Transfer Key Index.
The range for the transfer key index is 1-4. The following command sets the Transfer Key
Index to 4.
DLINK-AP#
3. Set the Key Length
For the CLI, valid values for Key Length are 40 bits, 104 bits, or 128 bits.The Key Length
values used by the CLI do not include the initialization vector in the length. On the Web
UI, longer Key Length values may be shown which include the 24-bit initialization vector.
To set the WEP Key Length to 64-bits, enter the following command:
set interface wlan0 wep-key-length 40
To set the WEP Key Length to 128-bits, enter the following command:
set interface wlan0 wep-key-length 104
140 © 2001-2008 D-Link Corporation. All Rights Reserved.
( ). For interface commands on VAPs 1-7, use
wlan0
the radio, and is the VAP ID. For example, to configure security on VAP 3
y
on radio 2, use
wlan1vap3
commands.
set interface wlan0 security static-wep
set interface wlan0 wep-default-key 4
Command
For VAP 0 on radio 1:
get interface wlan0 security
For VAP 3 on radio 2:
get interface wlan1vap3 security
For VAP 0 on radio 1:
get interface wlan0 detail
For VAP 3 on radio 2:
get interface wlan1vap3 detail
set interface wlan0 security plain-text
set interface wlan1vap3 security plain-text
See the detailed example in
page 140.
See detailed example in See
page 142.
See detailed example in "Set Security to WPA/WPA2 Personal
(PSK)" on page 143
See detailed example in "Set Security to WPA/WPA2
Enterprise (RADIUS)" on page 144
instead of in all of the following
wlan0
"Set Security to Static WEP"
"Set Security to IEEE 802.1X"
, where is
x
wlanxvapy
on
on