NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual page 64

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Table 3-1. General Information Fields
Field
Access Point Information
Access Point Name
(NetBIOS name)
MAC Address
Country/Region
Firmware Version
Access Point Mode
VLAN(802.1Q)
Management VLAN ID
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
3-6
Description
The default name may be changed if desired.
Displays the Media Access Control address (MAC address) of the
wireless access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It may not be legal to operate this wireless access
point in a region other than one of those identified in this field.
The version of the firmware currently installed.
Identifies the operating mode of the WG302: Access Point, Point-to-
point bridge, Multi-point bridge or Repeater.
Shows whether the VLAN feature is enabled or disabled. Default is
disable.
If VLAN has been enabled, the default VLAN address ID of "1" is
entered to handle traffic and connections on the access point. (Cannot
be configured by the user.)
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a
DHCP server on your network. Disabled indicated a static IP
configuration.
v4.0, April 2006
Management