Configuring Wpa And Wpa2 With Radius - NETGEAR WG302 - 802.11g ProSafe Wireless Access Point Reference Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG302 Reference Manual
Figure 2-16.

Configuring WPA and WPA2 with RADIUS

Not all wireless adapters support WPA and WPA2. Client software is required on the client:
• Windows XP and Windows 2000 with Service Pack 3, or above, do include the client software
that supports WPA. The wireless adapter hardware and driver must also support WPA.
• Service Pack 3 does not include the client software that supports WPA2. Make sure your client
card supports WPA2. The wireless adapter hardware and driver must also support WPA2.
Consult the product documentation for your wireless adapter; WPA client software for instructions
on configuring WPA settings; and WPA2 client software for instructions on configuring WPA2
settings.
To configure WPA and WPA2 with RADIUS:
1. Under Security on the main menu, select RADIUS Server Settings. The Select RADIUS
Server Settings screen will display.
2. Enter the RADIUS settings as shown in
on page 2-21.
3. Click Apply to save your RADIUS settings
4. Select Security Profile Settings under Security on the main menu, When the screen displays,
check the radio button of the Security Profile you are editing and click Edit.
Basic Installation and Configuration
"Configuring RADIUS Server Settings (if required)"
v4.0, April 2006
2-29