Nicam (Sv-675Gx/ Sv-671Gx Only); Protecting A Recorded Cassette; Recording A Programme Immediately - Samsung SV-270GX Instruction Manual

NICAM
(SV-675GX/SV-671GX Only)
NICAM programmes are divided into 3 types.
NICAM Stereo, NICAM Mono and Bilingual
(transmission in another language). NICAM
programmes are always accompanied by a standard
mono sound broadcast and you can select the
desired sound. Please refer to page 22.
1
Press MENU on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the USER SET option.
3
Press the OK button to select this option.
Result: The USER SET menu is displayed.
4
Press the corresponding
NICAM option is selected.
5 Press ➛ or ❿, until...
To...
Mono mode OFF is displayed.
OFF: Only set at this position to
record the standard mono
sound during a NICAM
broadcast if the stereo
sound is distorted due to
inferior reception conditions.
NICAM mode ON is displayed.
ON: Normally set at this position.
6
On completion, press MENU twice to exit the
menu.

Protecting a Recorded Cassette

Video cassettes have a safety tab to prevent accidental
erasure. When this tab has been removed, you cannot
record on the tape.
1 If you wish to protect a cassette, break off the tab
using a small screwdriver.
2 To re-record over a protected cassette (safety tab
broken), cover the hole with adhesive tape.
or ➛, ❿ buttons to
,
❷
or buttons, until the
❷
ENG-16
Recording a Programme
Immediately
Before recording a programme, you must have
preset the corresponding station (unless you are
recording via an external video source). If you
have not done so, refer to pages 12 and 13.
1
Switch on the television.
2
To monitor the programme being recorded, select
the television channel reserved for use with your
VCR (or the AV input if used).
3
Insert the cassette on which the programme is to
be recorded, with the window visible and the
safety tab intact or the opening covered with
adhesive tape.
Result: The VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG/TRK
or ❷) / PROG (
(
or
The AV1, AV2 or AUX (SV-675GX/ SV-671GX
only) source using the INPUT button for a
satellite tuner or external video source
Result: The station number is displayed and the
programme can be seen on the television.
With SV-675GX/SV-671GX/SV-475GX/
SV-470GX, you can select the recording speed
(SP/LP). Press the SPEED button.
5
Hold REC down for a while to start recording.
Result: The record indicator appears on the
television and VCR display. An index is
recorded on the tape (see page 24).
6
To stop recording, press
If the cassette is ejected when you
start recording, check that the safety
tab is intact or the opening is covered
with adhesive tape.
If you reach the end of the tape while
recording, the cassette rewinds
automatically.
or ❷) buttons
once.