Table of Contents
Advertisement
NICAM
(SV-M620K Only)
NICAM programmes are divided into 3 types. NICAM
Stereo, NICAM Mono and Bilingual (transmission in
another language). NICAM programmes are always
accompanied by a standard mono sound broadcast and
you can select the desired sound.
Please refer to page 23.
1
Press MENU on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding
select the USER SET option.
3
Press the OK button to select this option.
Result: The USER SET menu is displayed.
OPTIONS
PROG
OPTIONS
INSTALL
CLOCK
BONUS
LANG
USER SET
➛❿
OK
END:
❷
4
Press the corresponding
NICAM option is selected.
OPTIONS
OSD
:ON
TAPE SELECT
:E180
COLOUR SYSTEM
:AUTO
FORMAT 16:9
:AUTO
NICAM
:ON
IPC
:ON
❿
END:
❷
➛
5
To...
Press
Mono mode
OFF is displayed.
OFF: Only set at this position to record
the standard mono sound during
a NICAM broadcast if the stereo
sound is distorted due to inferior
reception conditions.
NICAM mode ON is displayed.
ON: Normally set at this position.
6
On completion, press MENU twice to exit the menu.
➛
❿
,
or
,
buttons to
❷
MENU
or
buttons, until the
❷
MENU
❿
or
, until...
Recording a Programme
Recording a Programme
acxz
Immediately
Immediately
Before recording a programme, you must have preset
the corresponding station (unless you are recording via
an external video source). If you have not done so,
refer to pages 14 or 15.
1
Switch on the television.
2
To monitor the programme being recorded, select
the television channel reserved for use with your
VCR (or the AV input if used).
3
Insert the cassette on which the programme is to be
recorded, with the window visible and the safety tab
intact or the opening covered with adhesive tape.
Result: The VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG/TRK
(
or
❷
) / PROG (
or
The AV1, AV2 or AUX source using the INPUT
button for a satellite tuner or external video
source
Result: The station number is displayed and the
programme can be seen on the television.
With SV-M620K/SV-M80K, you can select the
recording speed (SP/LP). Press the SPEED button.
5
Hold REC down for a while to start recording.
Result: The record indicator appears on the
television and VCR display. An index is
recorded on the tape (see page 25).
6
To stop recording, press
If your VCR ejects the cassette when you start
recording, check to make sure that the cassette's
safety tab is intact or that the opening (created by
a broken safety tab) is covered with adhesive tape.
If you reach the end of the tape while recording,
the cassette rewinds automatically.
Protecting a Recorded Cassette
Video cassettes have a safety tab to prevent accidental
erasure. When this tab has been removed, you cannot
record on the tape.
1 If you wish to protect a cassette, break off the tab
using a small screwdriver.
2 To re-record over a protected cassette (safety tab
broken), cover the hole with adhesive tape.
ENG-18
or
❷
) buttons
once.
Advertisement
Table of Contents
