Recording A Programme With Automatic Stop; Using The Showview Feature (Sv-675Gx/ Sv-475Gx/Sv-275Gx Only) - Samsung SV-270GX Instruction Manual

Recording a Programme with
Automatic Stop
BThis function enables you to record up to nine
hours of programmes. (LP)
Your VCR stops automatically after the
requested length of time.
1 Switch on the television.
2 To monitor the programme being recorded, select
the television channel reserved for use with your
VCR (or the AV input if used)
3 Insert the cassette on which the programme is to
be recorded, with the window visible and the
safety tab intact or the opening covered with
adhesive tape.
Result: The VCR is switched on automatically.
4 Select:
The station to be recorded using the
or ❷) / PROG (
PROG/TRK (
buttons
or
The AV1, AV2 or AUX (SV-675GX/ SV-671GX
only) source using the INPUT button for a
satellite tuner or external video source
Result: The channel number is displayed and the
programme can be seen on the television.
With SV-675GX/SV-671GX/SV-475GX/
SV-470GX, you can select the recording speed
(SP/LP). Press the SPEED button.
5 Hold the REC button down for a while to start
recording.
Result: The record indicator appears on the
television screen and VCR display. An index
is recorded on the tape (see page 24).
6 Press the REC button several times to increase
the recording time in:
30-minute intervals up to four hours
1-hour intervals up to nine hours (LP)
Result: The length is displayed on the television
displays. The selected programme is
recorded for the length of time requested.
At the end of that time, the VCR stops
recording automatically.
7 If you wish to cancel the recording before the end,
press VCR STANDBY/ON (STANDBY/ON).
If the end of the tape is reached while recording:
The recording stops
The VCR automatically turns off
Using the ShowView Feature ( SV-
675GX/SV-475GX/SV-275GX Only)
Before presetting your VCR:
Switch on both the television and your VCR
Check that the date and time are correct
Insert the cassette on which the programme
is to be recorded (safety tab intact)
Up to six programmes can be preset.
1
Press the TIMER button.
Result: The TIMER METHOD is displayed.
2
Press the corresponding
the SHOWVIEW option is selected.
3
Press the ❿ button to select SHOWVIEW.
Result: A message is displayed to allow you to
or ❷)
4
Press the numeric buttons to enter the code
opposite the programme that you wish to record
in your television magazine.
If you wish to correct the ShowView code that
you are entering:
5
Press the MENU button.
Result: The information concerning the
6
If the programme and times are correct, press the
MENU button.
7
Press the VCR STANDBY/ON (STANDBY/ON)
button to activate the timer.
Result: The Record indicator (
ENG-17
or
enter the ShowView code.
If all six programmes have been set, the
message TIMER IS FULL is displayed.
Refer to page 19 if you wish to cancel a
preset recording.
Press the ➛ button until the digit to be
corrected is cleared
Enter the correct digit
programme is displayed.
When using the ShowView function for the
first time with stored stations, the programme
number flashes. This one time, you must
enter the station number manually by
pressing the or buttons. Refer to the
❷
following page if:
The programme number or times flash
You wish to modify the programme
buttons, until
❷
V
) is displayed.