Table of Contents
Advertisement
3.2
Wide Open Throttle Module Wiring Diagram
Wide Open Throttle
(WOT) Module
Red
Fuse
w/Holder
Battery
3.3
Nitrous Electrical System Installation Procedure
Determine a location for the Wide Open Throttle relay and fuse holder wire. Most common installations locate these components
close to the battery. However, these connectors are water-resistant not waterproof, so care is required when mounting this
assembly under the hood of your vehicle.
Wire Schematic Origin and Destination Map
Wire Color
Red
Yellow
Blue
Blue
Black
Black
Black
Tan/Yellow
3.4
Wide Open Throttle (WOT) Module Installation
The WOT module includes 3 feet of color-coded wires and terminals to make the electrical system installation for your Edelbrock
Nitrous System as easy as possible. We recommend that you do not cut any lengths of wires from the wire harness or complete
the wiring of the system until all of the mechanical components are securely mounted in their permanent locations.
Once all the solenoid and switches are placed, route the un-cut wires from the harness to each location allowing enough wire
length on each circuit to not interfere with operating linkages, heat sources, brackets, etc. Pay particular attention to sharp
edges along the route of your wire harness as they can chafe the wire and cause your system to fail.
Once you have decided the location of the "WOT" module secure it with fasteners (not included with kit) such as sheet metal
screws, bolts and nuts, etc. Allow for some slack in the red wire that connects the "WOT" module and fuse holders together.
The relay in the WOT Module is rated for 30 AMP and the fuse is 15 AMP.
©2007 Edelbrock Corporation
Brochure #63-0478
Yellow
Black
Blue
Fuel
Solenoid
Ground
System
Main System Power
Solenoid Power
TPS 5 Volt Input
TPS 5 Volt Input
WOT Module Ground
Solenoid Ground
Solenoid Power In
TPS 5 Volt Reference
Nitrous
Ground
Solenoid
Ground
ECM Pin #61
Origin
WOT Module
WOT Module
WOT Module
Arming Switch
WOT Module
Solenoid
Solenoid
Throttle Body
Page 11 of 16
Throttle
Position
Ylw/Wht
Sensor
(Located on
Throttle
Body)
Destination
Terminal Used
Bat. +12V Signal
Solenoid
Arming Switch
TPS Sensor
Splice Connector
Chassis Ground
Chassis Ground
WOT Module
ECM Harness
Ring
Spade
Spade
Ring
Ring
Spade
-
Catalog #70410
Rev. 9/08 - AJ/mc
Advertisement
Table of Contents
