Table of Contents
Advertisement
MCD-SF85(GB-SECA) 2004.11.9 2:27 PM Page 23
Presetting Stations
You can either manually or automatically preset and store FM stations.
Manually presetting stations
EXAMPLE: Storing an FM station at 89.1 MHz into preset number 2
1
Tune to 89.1 MHz and then press the
AL/+10/MEM button on the remote
control.
• "PSET" flashes.
2
Press
or
to select the preset
number 2.
• Each time the button is pressed a higher or
lower preset number is selected.
3
Press the AL/+10/MEM button again to
store the selected station.
• The preset number disappears, indicating
that the station has been stored.
• Repeat steps 1 to 3 to change the station or
store other stations. You can preset up to 15
stations.
23
PSET
AL/+10/MEM.
PSET
AL/+10/MEM.
Automatically presetting stations
Press and hold the Mode/P.SET button on the remote control.
• "PSET" flashes. Then, each frequency of the received station
is incrementally stored into the preset numbers from 1 to 15.
• When a station is stored, the station is heard for about 3 seconds
before the automatic preset tuning resumes again.
Note
• In a poor reception area, the total number of preset stations may
not reach 15.
Tuning in to a Preset Station
1
Press the Mode/P.SET button.
• "PSET" and the station freguency stored
under that preset number appear on the
display.
2
Press
or
to select the desired
preset number.
• "PSET" remains, and the frequencies of the
preset stations are displayed in turn.
Mode/P.SET
Mode/P.SET
PSET
PSET
24
Advertisement
Table of Contents
