Table of Contents
Advertisement
MCD-SF85(GB-SECA) 2004.11.9 2:27 PM Page 11
Preparation before using your unit
Using standard batteries
1
Attach the external battery pack as
shown in the picture.
• Then, turn the lock control to secure
firmly in place.
2
Open the cover of the battery
compartment.
3
Carefully check the correct orienta-
tion of the positive and negative ter-
minals of the batteries.
• Use two AA/R6 type 1.5 V batteries.
Use two AA/R6 alkaline batteries. Manganese
batteries have a shorter battery life.
Battery Life
(Using alkaline batteries)
Rechargeable
Rechargeable Batteries +
Batteries
Battery Pack (type AA/R6)
MP3-CD
9 hours
20 hours
CD(when ESP is off)
8 hours
16 hours
CD(when ESP is on)
6 hours
14 hours
30 minutes
•
Replace the batteries if the remaining battery power indicator "
Time for Bat-
•
Even though the remaining battery power indicator "
tery Replace-
batteries have already expired, the LCD remote control will not be lit.
•
ment
Should "
" flash, the player will automatically turn off the CD ESP ON mode to
conserve battery power consumption.
•
Standard batteries cannot be recharged.
•
The external battery pack cannot charge, as it does not have the capacity to charge.
•
Warning
Do not mix old and new batteries.
11
•
Remove the batteries if they will not be used for a long time.
•
Remove the standard batteries when you use an AC adaptor.
(not supplied)
" flashes.
" may be flashing, if the
In-car use
Only use the supplied SCJ-1 DC car adaptor (4.5 V, DC) and
the STA-1 car cassette adaptor. Any other product
may damage the unit.
1
Put the CD player on a horizontal, vibration-
free and stable surface. Make sure it is a safe
place, where the player is not a danger or an
obstacle to the driver and passengers.
2
Connect the DC plug of the DC car adaptor to the 4.5V DC IN of the
CD player (for a 12V car battery only, negative grounding).
3
Insert the DC car adaptor into the cigarette lighter socket. If necessary,
clean the cigarette lighter socket to obtain good electrical contact.
4
Turn down the volume and connect the car cassette adaptor plug to
the LINE OUT of the CD player.
5
Carefully insert the car cassette adaptor into the car radio's cassette
compartment.
6
Start the CD player and adjust the sound with the car radio controls.
Note
• You cannot use this car cassette adaptor with some car cassette deck.
•
Do not expose to strong sunlight or very high temperatures.
• If your car radio has a LINE IN socket, use the LINE IN socket for the car radio
connection instead of the cassette adaptor. Connect the signal lead to this LINE
IN socket and the LINE OUT socket of the CD player.
• Make sure the cord does not hinder your driving.
• Always remove the DC car adaptor from the cigarette lighter socket when the
CD player is not in use.
SCJ-1
STA-1
4.5V DC IN
12
Advertisement
Table of Contents
