Edelbrock E-Force 1580 Installation Instructions Manual page 8

4.6l mustang gt supercharger system for 2005 and later mustang gts

7. Use an 8mm socket with a 12" extension bar to

remove the three bolts holding the battery tray in place,

then use a panel puller to detach the wiring harness clip.

Remove and set aside the tray.

Bolts

8. Use a flat blade screwdriver to pry up the head of the

six push-pins that retain the radiator shroud, then use a

panel puller to fully remove the push-pins. Lift the shroud

off the car and set it and the push-pins aside.

Part #1580 & 1585

III. Removing Engine Components

9. Detach the charge motion control valve (CMCV)

electrical connector at the rear of the manifold. Seperate

the wiring retainers from the intake manifold stud and the

CMCV bracket, then move the wiring harness to the side.

Wiring Harness Clip

10. Detach the throttle position sensor (TPS) and

electronic throttle control (ETC) connectors from the

throttle body.

ETC

Page 8

Edelbrock 4.6L Ford Supercharger System

for 2005 and later Mustang GTs

Installation Instructions

TPS

Brochure #63-1580

Rev. 1/11 - AJ/mc

E-force 1585