Advertisement
31. Use a 10mm socket to remove the two outer
alternator bracket bolts, and an 8mm socket to remove
the two inner alternator bracket bolts.
32. Use a panel puller to remove the harness locating pin
from the alternator bracket, remove the bracket, then
disconnect the alternator electrical connector. Trace the
alternator harness back to where it clips into the main
harness and detach it. This wire may now be discarded.
33. Push aside the protective boot to access and remove
the nut retaining the alternator power wire. The power
wire will not be reused and can be discarded. The
alternator can now be lifted out and set aside.
©2011 Edelbrock LLC
Part #1580 & 1585
8mm
10mm
Edelbrock 4.6L Ford Supercharger System
for 2005 and later Mustang GTs
Installation Instructions
IV. Front Fascia
34. Use a 10mm socket to remove the two upper front
bumper cover bolts, located between the grille and
headlights.
35. Use a jack and jack stands or a service lift to raise
the front of the vehicle. Use a 5.5mm (or 7/32") socket to
remove the seven bolts that retain the lower splash shield,
then set the shield and bolts aside.
36. Remove the five push-pins and three screws that
secure each of the front inner fender wells. Note that the
front inner fender wells are divided in two sections, but
you will only need to remove the forward half. Turn the
head of push-pins that have a philips head recess on
them about a quarter turn or until the head pops up, then
fully remove the pin with a panel puller. Remove and set
aside the forward half of both front inner fender wells.
Page 12
Brochure #63-1580
Rev. 1/11 - AJ/mc
Advertisement
