Advertisement
136. Install the new high flow air filter in the airbox.
137. Use a T20 Torx driver to install the new MAF sensor
in the air cover outlet tube, torque the two screws that
retain it to 18 in/lbs., then reinstall the cover.
138. Install the throttle body elbow onto the throttle body
and secure it with the provided hose clamps. The flexible
elbow should be oriented so that it can be easily mated to
the air cleaner cover outlet tube. Install the air box cover,
clamp it down and attach the MAF connector to the sensor.
139. Route the new driver side PCV hose between the
valve cover and intake elbow, then install the passenger
side PCV hose between the fitting on the throttle body and
valve cover.
©2011 Edelbrock LLC
Part #1580 & 1585
Edelbrock 4.6L Ford Supercharger System
for 2005 and later Mustang GTs
Installation Instructions
140. Install the ETC extension harness and attach the
electrical connectors for the TPS and ETC stepper motor.
141. Install the 12" piece of 3/4" hose from the recovery
tank to the intercooler manifold fitting. Secure each end
with a clamp.
142. Route the other end of the hose up to the intercooler
manifold outboard of the A/C line, avoiding close proximity
to the exhaust manifold and power steering pump, and
attach it to the manifold fitting with a clamp.
143. Install the thermostat, o-ring & housing (thermostat
and housing supplied in #15804 for '05-'06 applications,
all model years reuse stock o-ring) onto the driver side of
the water crossover. Torque the thermostat housing bolts
to 7-1/2" ft/lbs. Install the stock molded hose onto the
thermostat housing and line the other end up with the
passenger side radiator fitting. Trim 1-1/2" from the
radiator side of the hose to achieve the best fit.
Page 26
Brochure #63-1580
Rev. 1/11 - AJ/mc
Advertisement
