Searching For A Specific Sequence; Using The Tape Counter - Samsung DVD-CM350 Instruction Manual

VCR

Searching for a Specific Sequence

GB
Each time you record a cassette on this DVD-VCR, an "index" is
automatically marked on the tape when recording starts.
The Search function allows you to fast-forward or rewind to a
specific index and start playback from that point. Depending on the
direction selected, the indexes are numbered as follows:
1
➢
INDEX : ➛ ➛¤¤¤¤❿ ❿
INTRO SCAN
1
2
INTRO SCAN : ➛ ➛¤¤¤¤
3
4
Index Skip Search:
This feature will enable you to fast forward/rewind to a specific
point on a tape: E.g. if you have recorded 3 different programmes
INDEX SEARCH : ➛ ➛ - 6
on a tape and you have rewound the tape to the beginning, by
using this feature you can go directly to the start of programme 2
simply by pressing the INDEX button.
1
2
3
4
2 2
40
Prev Seq. being Next
Seq. played Seq. etc.
etc.
2 1 1 2
This DVD-VCR uses a standard indexing system (VISS). As
a result, it will recognize any indexes marked by other
VCRs using the same system and vice versa.
To search for a specific index, press INDEX.
➛ ➛ ❿ ❿
Press the or buttons depending on the direction
where your desired programme is located.
When an Index mark is found the DVD-VCR will playback the tape
for 5 seconds, after which it will continue searching for the next
Index mark.
If you want to watch the tape from a particular Index, simply press
❿ II
.
Press the INDEX to start the Index search.
➛ ➛ ❿ ❿
Press the or buttons twice more. This will take
you directly to the start of the desired programme is located.
❿ ❿
These Index searches can be made forwards: (press ) or
➛ ➛
backwards: (press ).
❿ II
or I button.
To cancel an Index search simply press the

Using the Tape Counter

The tape counter:
N Indicates the elapsed time in the play and record modes
(hours, minutes and seconds)
N Is reset when a cassette is inserted in the DVD-VCR
N Allows you to find the beginning of a sequence easily
☛
If the remaining time is to be calculated correctly, you
must indicate the type of cassette being used.
1
Insert a cassette in your DVD-VCR.
2
To set the tape counter to zero at the beginning of a sequence:
N
Press DISPLAY twice to display the counter
N
Press CLEAR when you want to set the tape counter to zero
3
When you are ready,
N
Start playback or Recording.
N Press the I button.
N
To fast-froward or rewind to the sequence at which the
➛ ➛ ❿ ❿
counter was set to zero, press or .
➢
Some DVD-VCR information, such as the counter, can be
displayed on the television screen (unless you have
deactivated the OSD mode; refer to page 30).
Press DISPLAY:
N
Once to display the current function, programme
number, recording speed, date, time and counter
N
Twice to display the counter only
N
Three times to display the time remaining on the
cassette
N
Four times to clear the display
VCR
GB
0:00:00
2 2
41