Jet Map Information; Engine Operation Considerations - Edelbrock 70211 Installation Manual

2002-2003 ecotec 2.2l performer efi nitrous system
Table of Contents

Advertisement

1.2

Jet Map Information

delbrock Engineering has conducted dyno testing with the Edelbrock 2.2L Ecotec Performer EFI system to ensure
E
the horsepower increase with the nitrous system is as intended. On a typically stock 2.2L Ecotec engine, you can
expect the following approximate power gain:
Nitrous Jetting Fuel Jetting
.032
.036
The dyno tests were conducted at Edelbrock using a stock 2.2L engine. These tests were conducted with 950 psi
nitrous bottle pressure.
1.3

Engine Operation Considerations

When used correctly, nitrous oxide safely elevates cylinder pressures and temperatures while increasing
combustion rate. These characteristics make the engine more sensitive to detonation. To ensure proper
performance, engine and drive line life, the following tips are suggested:
Never exceed the recommended jetting!! Excessive jetting will result in severe engine damage.
Because Nitrous oxide is an oxidizer, fuel selection is critical. Both octane and fuel consistency affect fuel burn rate.
The oxidizer quality of nitrous oxide will accelerate the burn rate, so we recommend a high quality of gasoline. We
also recommend you use the same grade of gasoline every time you use your nitrous oxide system. This will help
maintain the same fuel burn rate every time.
Most aftermarket performance chips increase the vehicle's ignition timing, which can cause detonation with the use
of nitrous oxide. Please consult with your chip manufacturer on information regarding the compatibility of your chip
with nitrous oxide use.
If your vehicle is equipped with platinum type spark plugs, we highly recommend they be removed and replaced
with the equivalent standard type spark plug.
With all performance modifications, complementary system upgrades will always serve to elevate the consistency
and longevity of an engine, especially when using nitrous oxide as a power adder. Modifications such as ignition
upgrades, free-flowing exhaust, camshafts, cylinder heads, manifolds can all add to the performance of a nitrous
oxide injected engine.
©2003 Edelbrock Corporation
Brochure No. 63-0173
Approx. HP Gains
.042
.043
• System Jetting
• Ignition Components
• Engine System Upgrades
Page 6 of 23
50hp
60hp
• Fuel Quality
Final Air/Fuel Ratio
12.5:1
12.5:1
Rev. 02/03

Advertisement

Table of Contents
loading

Table of Contents