Motorola 4500 Manual page 30

Reference
To Select
1. Press R, *. The display will show the
current active system choice.
2. Repeatedly press * to review the system
type modes. (Press E to exit without
changing selections.)
3. Press s to activate the displayed
selection.
4. Press E to exit.
System Type Selection
Your telephone seeks cellular service according to
the mode you have selected. If you have selected
two-system operation, the phone seeks cellular
service according to the system type mode
selected for each phone number.
Constant flashing of R R o o a a m m , or a steadily lit N N o o S S v v c c
while within your home service area may indicate
an unintentional choice has been made. If this
occurs, re-enter system type selection to see if the
unit is operating in standard mode, or if an
alternate selection has been made.
5 5 8 8
System Type Selection
Standard Mode
Your phone first seeks a home type system,
then a non-home type.
If home system is type A
If home system is type B
Invert Preference Mode
Your phone first seeks a non-home type
system, then home type. (Select this mode if
in a fringe area of your home system or in
certain roaming situations.)
If home system is type A
Fast flashing Roam = call on B system
Slow flashing Roam = call on home
type system
Slow flashing In Use = call on home system
If home system is type B
Fast flashing Roam = call on A system
Slow flashing Roam = call on home
type system
Slow flashing In Use = call on home system
Home Only Mode
Phone will not operate outside its home system.
Scan A Mode
Phone will operate only within A
systems.
Scan B Mode
will operate only within B systems.
Preferred Scanning Mode
Unit will operate only within specifically
identified systems. This choice requires entry
of up to 60 System ID numbers for those
systems over which you wish to operate. The
SID digits are entered as obtained from your
Cellular Service Operator.
Reference
Display
Display
Std A B
Std B A
Scan B A
Scan A B
Home
Scan A
Scan B
PSCAN
5 5 9 9