Ringer Volume; Display Own Phone Number; Switch To Second Phone Number - Motorola 4500 Manual

Basic Operation

Ringer Volume

Press F and use G and H as described
in the "Volume Meter" on page 22.
The maximum number of bars that will display is six.
– – = = ≠ ≠
v

Display Own Phone Number

1. Press R, #.
The phone number that is currently active will be
displayed.
2. When you have finished viewing, press C.

Switch to Second Phone Number

1. Press R, #, s.
The display will go blank to confirm the switch and
the newly activated number will display.
2. When you have finished viewing, press C.
Your telephone can operate over two different
home systems, if you have made proper
arrangements with your Cellular System Operator.
Both are designated as your "home system" but
are accessed with separate telephone numbers.
While you may switch from one system to the
other, only one of the two can be active at any
given time. Calls are placed and received through
the active system only.
24
If you have two phone numbers programmed into
your phone, each time the telephone is turned on,
it displays a message indicating which home
system type and phone number is currently active.
The message shows the system type and phone
number applied, as follows:
System Type and
Phone Number
Non-wireline or A type
with phone number 1
Non-wireline or A type
with phone number 2
Wireline or B type with
phone number 1
Wireline or B type with
phone number 2
If a call is placed to the inactive phone number,
the caller will receive the recorded "Not In Service"
message.
When you turn your phone on, the telephone will
remember which system was active when you
turned it off. That system will stay active until you
change to the other system with the sequence R,
#, s. However, you cannot switch systems
during a call.
Basic Operation
Display
A 1
A 2
B 1
B 2
25