Table of Contents
Advertisement
Program timer (continued)
7
Press the VOLUME/
UP ( ) or DOWN ( ) key
TROL
to select "PLAY" or "AI PLAY",
then press the SET/DEMO key.
"PLAY" : The source will played at the
adjusted volume before entering the
STANDBY mode.
"AI PLAY" : The playback volume will in-
crease gradually after the start of timer
playback.
8
Press the VOLUME/
UP ( ) or DOWN ( ) key
TROL
to select the music source to
be input, then press the SET/
DEMO key.
The input source can be selected from
"CD", "MD" and "TUNER" (radio).
9
To listen to radio broadcast-
ing, press the VOLUME/
UP ( ) or DOWN ( )
CONTROL
key to select the preset num-
ber of the desired station, then
press the SET/DEMO key.
This operation is not required when an input
source other than "TUNER" is selected.
0
Press the VOLUME/
UP ( ) or DOWN ( ) key
TROL
to adjust the listening volume.
The source will be played at the adjusted
volume.
This step is not required when "AI PLAY" is
selected.
48
EN
7 Execution
!
MULTI CON-
@
MULTI CON-
To cancel program timer :
Press the TIMER key on the remote so that
"PROG.1" and "PROG.2" are not lit.
To check or change the timer setting :
Restart the procedure from step 1 again.
MULTI
÷ Be sure to adjust the time of the day (page 10)
÷ The program timer cannot be used for program
÷ PROG.1 and PROG.2 should be set so that their
MULTI CON-
÷ The program timer setting is held in memory even
÷ If the STANDBY/TIMER indicator is blinking in
Press the TIMER key on the
remote repeatedly so that
the program number to be
executed ("PROG.1" or
"PROG. 2") is lit.
Program No.
Press the POWER
put the unit in the STANDBY
mode.
When the timer program is activated and
the unit enters the STANDBY mode, the
STANDBY/TIMER indicator lights in green.
When the set ON time comes, the timer
program is executed and playback starts.
before using the timer functions.
playback of CD or MD.
operating periods do not overlap. Leave at least 1
minute of interval between the two programs.
after it is canceled. The program timer setting
remains in memory unless it is newly set again.
green, the timer setting may be erroneous or the
time of the day is not adjusted. Re-set the appli-
cable item.
key to
Hide quick links:
Advertisement
Table of Contents
