Kenwood MDX-01 Instruction Manual page 50

To cancel program timer :
Press the TIMER key on the remote so that
"PROG.1" and "PROG.2" are not lit.
To check or change the timer setting :
Restart the procedure from step 1 again.
÷ Be sure to adjust the time of the day (page 10)
before using the timer functions.
÷ PROG.1 and PROG.2 should be set so that their
operating periods do not overlap. Leave at least 1
minute of interval between the two programs.
÷ The speakers do not output audio during timer
recording.
÷ The program timer setting is held in memory even
after it is canceled. The program timer setting
remains in memory unless it is newly set again.
÷ If the STANDBY/TIMER indicator is blinking in
green, the timer setting may be erroneous or the
time of the day is not adjusted. Re-set the appli-
cable item.
50
EN