Kenwood HM-DV6MD Instruction Manual page 69

4
Start recording.
1
Press the MODE key.
2
Turn the VOLUME/MULTI CONTROL knob
to select "O.T.E. MODE", then press the
SET/DEMO key.
3
Turn the VOLUME/MULTI CONTROL knob
to select "NORMAL SP" or "HIGH SP", then
press the SET/DEMO key.
If you are operating the remote, press the O.T.E.
key. (Only "NORMAL SP" recording is available
from the remote control unit.)
The recorded audio may skip, noise may be recorded
on the MD or unnecessary tracks may be created de-
pending on the condition of the CD. In such a case,
restart recording at the normal speed.
To interrupt a recording
TUNING MODE
(Recording and playback will be stopped)
MODE
STOP 7
Convenient recording methods
Turning the knob switches the display contents.
1 "NORMAL SP" : Normal-speed recording
2 "HIGH SP" : High-speed recording
÷ Recording begins from the first track in the program and
completes when the entire program has been recorded.
÷ When either the playback of CD (VCD) or recording of
MD is stopped, the other operation is stopped auto-
matically.
With certain tracks, when a track has been recorded
in high-speed recording, the recording mechanism
prohibits to start high-speed recording of the same
track or high-speed recording of the disc containing
the track in less than 74 minutes after the start of pre-
vious recording. In this case, the unit displays the time
required till the high-speed recording can be re-
started.
W a i t
If you want to record the same track immediately
after its high-speed recording, record it in nor-
mal-speed recording.
Do not turn power off or apply shock or impact
while "WRITING" is displayed. If the power cord is
unplugged before "WRITING" disappears, the re-
corded or edited data will be lost.
7 4 m i n .
69