Table of Contents
Advertisement
Connection of external source component
Analog signal connection
The AUDIO AUX IN (AUDIO AUX OUT) input jacks on the rear panel can be used to connect a cassette
deck, etc.
L
R
AUX
AUX
OUT
IN
AUDIO
Digital signal connection
The OPTICAL digital input jack on the rear panel can be used to connect a digital component.
The recommended setup for "Digital Audio" is variable depending on the equipment connected to the digital
audio output. T
PCM/BIT
PCM
STREAM
OPTICAL
OPTICAL
DIGITAL IN
DIGITAL OUT
*
*
DTS disclaimer clause
When playing DTS-encoded (CDs, LDs, DVDs), excessive noise will be exhibited from the analog stereo
outputs. To avoid possible damage to the audio system, the consumer should take proper precautions
when the analog stereo outputs of the DVD player is connected to an amplification system. To enjoy
DTS Digital Surround™ playback, an external 5.1 channel DTS Digital Surround™ decoder system must
be connected to the digital output (S/P DIF, AES/EBU, or TosLink) of the DVD player.
1. This unit always down-mixes multi-channel surround audio into 2-channel audio and outputs it from the
AUDIO AUX OUT, DIGITAL OUT OPTICAL and PHONES jacks. However, with certain discs, this unit
outputs only the Front (L/R) channel signals in place of the down-mixed 2-channel signals.
2. In case an associated system component is connected, also read the instruction manual of the component.
3. Insert the optical-fiber cable straight into the connector until it clicks.
4. Never bend or bundle the optical-fiber cable.
Optical fiber cable
Digital outputs are available only from DVD, VCD and CD.
Cassette deck etc.
audio input
audio output
System connection
2
3
0
7
8
¶
1
¡
Digital component
Optical digital audio output
AV Amplifier
Optical digital audio input
9
Advertisement
Table of Contents
