Kenwood DVF-R9050 User Manual page 59

[Surround speakers setting]
Speaker Setting (Custom)
SL Exit
Size Large Normal Off
Level -12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0
dB
Delay Time
0 5.3 10.6 15.9
ms
0 dB
C
0 dB
0 ms
L R
0 dB
SW
SL
0 dB 0 ms 0 dB
Size: Select "Normal" when the connected speaker
is incapable of reproducing audio below 100 Hz.
Select "Large" when the connected speaker can
reproduce audio below 100 Hz.
Use of surround speaker: Select "Off" if the
surround speaker is not used.
Level: Set the volume level.(0 ~ -12 dB)
Delay Time: Set the delay time. For the setting value,
see "Delay Time Setting".
After completing the speaker setting, select "Exit"
to enter the setting and return to the screen in step
5.
[Subwoofer setting]
Speaker Setting (Custom)
SW
Size On
Level
-12 -11 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0
0 dB
0 dB
L
0 dB
SW
SR
SL
0 dB
Use of subwoofer: Select "Off" if the subwoofer is
not used.
Level: Set the volume level.
After completing the speaker setting, select "Exit"
to enter the setting and return to the screen in step
5.
Exit
Off
dB
0 dB
C
0 dB
0 ms
R
SR
0 ms 0 dB
Chapter 6: Various Setups
7.
After completing the speaker settings, select "Test"
by tilting the joystick up/down or to the left/right and
press . The cursor will automatically move across
ENTER
the speakers in sequence from "L" and the test tone
is output from each speaker indicated by the cursor.
Press again to display the speaker setting screen
ENTER
for the speaker being indicated by the cursor.
¶ The cursor skips the subwoofer and the speakers
set to "Off" and test tone is not output from them.
¶ After adjusting the level of each speaker channel
by tilting the joystick to the left or right, press the
ENTER button, then select "Exit" and press the
ENTER button to restart the test tone output.
Repeat the volume level adjustment until the
volumes of all speakers are identical.
¶ When the joystick is tilted in any direction during
the test tone output, the test tone output stops.
(The same effect can also be obtained by pressing
the RETURN button)
8.
After completing the speaker setting, select "Exit" and
press to enter the setting in memory.
ENTER
¶ As the test tone is not output from the subwoofer,
its volume level should be adjusted after listening
to the actual sound.
59