Selectable Illumination; Non-Fading Preout; Balanced Output; Security Code - Kenwood KDC-PS907 Instruction Manual

Other features
(See page 10)

Selectable Illumination

You can switch the setting of the button illumination between
green and amber, or turn the illumination off.
Switching the illumination:
Press the ILLUM button for at least one second to switch the
illumination setting as follows:
▼
Green
▼
Amber
▼
Light Off

Non-fading Preout

The non-fading sound output can be set to either ON or OFF.
The factory default is set to ON.
Turning non-fading output On/Off:
Press the NF button for at least one second to set the function
ON or OFF.
"NF ON" is displayed when the non-fading output is set ON.

Balanced Output

You can change preouts to balanced outputs, which allows
you to reduce noise if the amplifier being connected has
balanced input.
The balanced monaural sound output can be set to either ON
or OFF. The factory default is set to ON.
Switching balanced / unbalanced output:
1
Press the TUN button repeatedly and switch the display to
"ALL OFF" to enter the standby mode.
2
Press the #3 button for at least three seconds.
Balanced output is selected when "BALANCED" appears in the
display.
The front/rear output corresponds to the L/R channels during
balanced output. The non-fading preout will change to
30
monaural (mono) sounds during balanced output.
UNBALANCED
Left
FRONT
Right
Left
REAR
Right
Left
NON-FADING
Right
You can switch between balanced and unbalanced output by
repeating steps 1 and 2 above.
NOTE
• The audio control returns to factory default settings each time
you switch between balanced and unbalanced output.
• The non-fading output/ balanced monaural output setting turns
ON each time you switch the output between balanced and
unbalanced.
Turning monaural output ON/OFF:
Press the NF button for at least one second to set the function
ON or OFF.
"SUB ON" is displayed when the monaural output is set ON.

Security Code

When the battery is removed from the unit's power switch,
you cannot turn on the unit again unless the preset security
code is input. This function helps prevent theft.
NOTE
You must follow steps 1 to 7 to be able to use the Code Security
function. Turning off the power during the procedure will
deactivate the security code setting.
You cannot turn off the function after having completed these
steps.
1
Select the four digits to use in your security code.
NOTE
The four-digit security code is very important, as you will need it
BALANCED
Left -
Right -
Left +
Right +
Monaural +
Monaural -