Valet Mode - Kenwood KDC-PS907 Instruction Manual

to turn the unit on again when the code security function is on.
Choose the number carefully and do not forget it (write it down
and keep it separately in a safe place).
2
Press the TUN button repeatedly and switch the display to
"ALL OFF" to enter the standby mode.
3
Press button #6 for at least three seconds.
"ENTER" will appear in the display for one second, indicating
the code setting mode has been entered. When "CODE"
appears in the display, you can start inputting the code.
4
Press the preset button and enter the security code that you
have selected in step 1.
Example: Use "3510" as the security code.
Step Button to press
1 #1
2 #2
3 #3
#4
4
5
Press the NAME.S button for at least three seconds.
The security code will be set.
"RE-ENTER" will appear in the display for one second, asking
you to enter the code once again for confirmation. When
"CODE" appears in the display, you can start inputting the
code.
6
Press the Preset button and input the security code again.
7
Press the NAME.S button again for at least three seconds.
"APPROVED" will appear in the display, with the code security
function turning on. From this point on, if the unit is
disconnected from the battery, the security code must be
entered the first time that the unit's power is turned on.
"CODE" will appear in the display, asking you to input the code.
NOTE
If you input an incorrect security code, the display ask you once
more to input the correct one. Follow the procedure in step 3
above.
# Times
Display
pressed
4 "3"
6 "5"
2 "1"
1 "0"
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "CODE" will appear in
the display, asking you to input the security code.
Repeat steps 6 and 7 above, and input the security code.
You can start operating the unit again when "APPROVED"
appears in the display.
If you enter the incorrect code, the power will turn off. Enter
the correct code to turn the unit on.

Valet Mode

The faceplate will not appear as long as the switch is not
changed, preventing tampering with the unit when you let
someone else drive the car.
Connecting Valet Cable:
Connect the pink valet cable to the ON/OFF switch, while
grounding the other side of the switch.
NOTE
• Make sure the unit is grounded properly, or else the unit may
not operate correctly.
• We suggest you install the valet cable in a place where the
ON/OFF switch is difficult to find.
Turning Valet Mode on:
1
Turn the ON/OFF switch on.
2
Turn the power off either by turning off the ignition or by
pressing the CLOSE/PWR OFF button for at least one second.
The valet function will turn on, and the faceplate will reverse to
hide the control panel. In this condition, the unit cannot be
turned on until the valet function is turned off.
NOTE
You can reverse the order of steps 1 and 2 and still activate the
valet mode.
Canceling Valet Mode:
Turn the ON/OFF switch off.
Turn the ignition on, or press "the touch-sensitive spot" at the
rear of the faceplate (see p.12) to make the control panel
appear.
31