Connecting Wires To Terminals - Kenwood DPX-MP5070 Instruction Manual

Connecting Wires to Terminals

Front left output (White)
Front right output (Red)
FM/AM antenna input
Wiring harness
(Accessory1)
Motor antenna control wire (Blue)
Power control wire (Blue/White)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
External amplifier control wire
(Pink / Black)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
30
|
English
���������
Fuse (10 A)
Depending on what antenna you are using, connect either to
the control terminal of the motor antenna, or to the power
���� ����
terminal for the booster amplifier of the film-type antenna.
When using the optional power amplifier, connect to its
������
power control terminal.
Connect to the terminal that is grounded when either the
telephone rings or during conversation.
����
To connect the KENWOOD navigation system, consult your
navigation manual.
To car light control switch
������
To "EXT.AMP.CONT. " terminal of the amplifier having the
���������
external amp control function.
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Car fuse box
ACC
AUX left input (White)
AUX right input (Red)
Rear left output (White)/
Subwoofer left output (White)
Rear right output (Red)/
Subwoofer right output (Red)
KENWOOD disc changer control input
To connect the Disc changer, consult
your Disc changer manual.
If no connections are made, do not
let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
�
Car fuse box
(Main fuse)
Battery
�