Performing The Initial Configuration - Cisco IAD2435-8FXS Quick Start Manual

No. LED/Color
PWR OK—green
1
FE ports 0/0, 0/1—green
2
T1/E1 CD (carrier detect)—green
T1/E1 AL—Amber
3
FXS port 0 through port 7—green Off—On hook
4
11

Performing the Initial Configuration

This section describes how to configure the Cisco IAD2430 series IADs to perform basic communication functions. You may
initially configure your router by using the Cisco IOS command-line interface (CLI) or by using the setup command facility. To
create the initial configuration, the setup command facility prompts you for basic information about your router and network.
Cisco IOS CLI
To configure the initial router settings by using the Cisco IOS CLI, follow these steps:
Set up a console connection to your router. The following message is displayed:
Step 1
...
router con0 is now available
Press Return or Enter. The following message is displayed:
Step 2
Cisco Configuration Professional Express (Cisco CP Express) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco." The default username and password have a privilege level of 15.
Please change these publicly known initial credentials using Cisco CP Express or the Cisco IOS CLI.
Here are the Cisco IOS commands.
username <myuser>
no username cisco
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP Express please follow the instructions in the QUICK START GUIDE for
your router...
...
User Access Verification
Username:
Enter the username cisco, and press Return or Enter. The following prompt is displayed:
Step 3
Password:
Enter the password cisco, and press Return or Enter. The following prompt is displayed:
Step 4
Router#
A message is displayed that is similar to the first message that directs you to change the username and password.
28
Description
Off—no power
Steady on—normal operation
Slow blink—bootup phase or in ROMMON monitor mode
Off—No link
Steady on—link
Blinking—TXD/RXD data
Off—no Carrier detect
Steady on—Carrier detect
Off—no Alarm condition
Steady on—Alarm condition
Steady On—Off hook
privilege 15 secret 0 <mypassword>