Chapter 5 Configuring The Router; Verifying The Front Panel Led Indications; Performing The Initial Configuration On The Router; Using The Cisco Setup Command Facility - Cisco WS-C1924-A - Catalyst 1900 24 Ports 10MB Switch Hardware Installation Manual

Chapter 5 Configuring the Router

Verifying the Front Panel LED Indications

The front-panel indicator LEDs described in
useful during power up.

Performing the Initial Configuration on the Router

Use any of the following tools to perform the initial configuration on the router:
•
•
•
Cisco recommends using Cisco Configuration Professional Express to perform the initial configuration
Note
on the router because it provides a web-based graphical-user interface (GUI).

Using the Cisco Setup Command Facility

Cisco Setup Command Facility lets you configure the initial router settings through a configuration
dialog. If you see the following messages, the router has booted and is ready for initial configuration
using the setup command facility.
If the system configuration dialog message does not appear, a default configuration file was installed on
the router prior to shipping. See the
page 5-6
The setup command facility prompts you to enter the information that is needed to configure a router
quickly. The facility steps you through a initial configuration, including LAN and WAN interfaces. For
more general information about the setup command facility, see
Configuration Guide, Release
Note •
•
OL-19084-02
Using the Cisco Setup Command Facility, page 5-3
Using Cisco Configuration Professional Express, page 5-6
Using the Cisco CLI—Manual Configuration, page 5-6
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
to configure the router.
The messages that are displayed will vary based on your router model, the installed interface
modules, and the software image. The following example and the user entries (in
as examples only.
If you make a mistake while using the setup command facility, you can exit and run the setup
command facility again. Press Ctrl-C, and enter the setup command in privileged EXEC mode
(Router#).
Table 1-4 provide power, activity, and status information
"Using Cisco Configuration Professional Express" section on
12.4.

Performing the Initial Configuration on the Router

Cisco IOS Configuration Fundamentals
Cisco 1900 Series Hardware Installation
) are shown
bold
5-3