Table of Contents
Advertisement
91-5431-10-00_ATT5870_R0JUN040
figure a
figure b
figure c
figure d
figure e
2/5/03
4:03 PM
Wall Installation
1
Connect the power cord and
telephone line cord to the underside
of the base, as shown (figure a).
2
Position the mounting bracket as
shown (figure b).
3
Feed the short telephone line cord
through the hole in the center of the
mounting bracket (figure b), align the
bracket with the base, and slide into
the hole on the base as shown (figure
c).
4
Lock the mounting bracket in place
(figure d).
5
Plug the short telephone line cord
into a modular wall jack, and mount
the base on the wall (figure e).
a)
Align holes on base with mounting
studs on wall jack.
b) Place power cord as shown.
c) Pull base down on mounting studs
until it locks into place.
6
Plug the power cord into an electrical
outlet not controlled by a wall switch
(figure e).
The ON/OFF light goes on, and CL flashes
in the Message Window.
Use only the power cord supplied
with this product. If you need a
replacement, call 1-800-222–3111.
7
Follow Steps 3–5 in "Table/Desktop
Installation."
Page 5
6
Advertisement
Table of Contents
