BEU SYSTEM PRACTICES
AT
TCo Standard
&
5011T01A "TOUCH-A-MATIC®" S SERIES TELEPHONE SET
IDENTIFICATION, INSTALLATION, CONNECTIONS, OPERATION,
1.
GENERAL
This section contains information on the
1.01
TOUCH-A-MA TIC S series I2-button, wall
type telephone set (Fig. I and 2).
Whenever this section is reissued, the reason(s)
1.02
for reissue will be listed in this paragraph.
This telephone set can only be used on
1.03
individual or single line TOUCH-TONE®
service.
This set is not designed for speakerphone,
Note:
loudspeaker,
service.
The set is available in the colors listed Table
1.04
A.
The only faceplate color available for
the automatic dialer is silver (-I22).
2.
IDENTIFICATION
The 5011TOIA wall telephone set has a
2.01
I2-button automatic dialing feature.
two top name and digit buttons are illuminated
by red and green light emitting diodes (LEDs).
The set also contains a TOUCH-TONE dial, tone
ringer, and a MIA handset.
Design Features:
2.02
Modular unit
•
Solid state circuit memory and network
•
Automatic dialing of up to I2 preprogramed
•
telephone numbers
Will store up to I6 digits per number
•
Scanned by Frank Harrell, {Cowboy Frank) Castle Rock, Colorado
BSP 503-400- 200-iOl 1980-09- Ql.jpg
AND MAINTENANCE
lead control, or party line
A
Not for use or disclosure outside the
Bell System except under written agreement
Capability to record, change, or delete
•
numbers in memory
Single button dialing and directory space
•
for names and telephone numbers
Two illuminated buttons to highlight important
•
telephone numbers
MIA handset
•
Electronic tone ringer
•
Internal SI sounder unit which provides
•
tones for automatic dialing, indicating proper
recording procedures, and for checking the
battery
Battery powered repertory dialer
•
Telephone number recording with handset
•
on- or off-hook.
not interfere with conversation
RECORD ON/OFF button protected during
•
normal usage by faceplate to prevent
The
inadverent erasure of stored numbers
Built in polarity guard.
•
Operating Features:
2.03
This set is not compatible with all
facilities due to limited available loop
current, and may not function properly
in all cases.
connected to these facilities, such
as
(SLC-1
long loops (over 1300 ohms), the
sets may not dial from the manual
NOTICE
Printed in U.S.A.
Feb 08, 2012 22:03:53
SECTION 503-400-200
Issue 1, September 1980
Off-hook recording does
When these sets are
analog
loop
carrier
type,
SLC-8
type)
systems
a n d
Page 1