Rps - 3Com 5500-EI PWR Getting Started Manual

108 A C: T
PPENDIX ECHNICAL
Standards Supported

RPS

Safety Requirements
EMC
Emissions
Immunity
Output Specifications
Output Voltage
Output Regulation
Output Noise and Ripple
Output Transient Response
Output Overcurrent Protection
Output Overvoltage Protection
Output Connections
S
PECIFICATIONS
SNMP
SNMP protocol (RFC 1157)
MIB-II (RFC 1213)
Bridge MIB (RFC 1493)
RMON MIB II (RFC 2021)
Remote Monitoring MIB (RFC
1757)
MAU MIB (RFC 2239)
MIB II Traps (RFC 1215)
RS232 (RFC 1659)
Interfaces (RFC 2233)
Ether-like MIB (RFC 2665)
MAU MIB (RFC 2668)
Bridge extensions (RFC 2674)
The RPS shall comply with the following safety standards:
EN60950, UL60950, CSA22.2 60950, IEC60950
When the output is floating (not referenced to earth), the RPS shall meet the
requirements for a Safety Extra Low Voltage (SELV) circuit as defined by these
standards
CISPR 22 Class A, EN55022 Class A, FCC Part 15 Subpart B Class A,
ICES-003 Class A, AS/NZS 3548 Class A, VCCI Class A,
EN61000-3-2, EN61000-3-3
EN 55024
54.5V + 0.1V dc at 25°C
+ 1%
< 100mV p-p over frequency bandwidth of 30Hz - 30MHz
< 5% at load variation 10-90%
90-10% Recover Time < 2msec
Between 105% - 130% full load
User definable to less than 59V
Unearthed positive (common) and negative connections
Terminal Emulation
Telnet (RFC 854)
Protocols Used for Administration
UDP (RFC 768)
IP (RFC 791)
ICMP (RFC 792)
TCP (RFC 793)
ARP (RFC 826)
TFTP (RFC 783)
DHCP (RFC 2131, RFC 2132, RFC 1534)
BOOTP (RFC 951, RFC 1497)
Network Login (IEEE 802.1x)
RADIUS (RFC 2618, 2620)
Link aggregation (IEEE 802.3ad)