Installing The Versarails Slide Assemblies - Dell PowerEdge 6850 Hardware Installation Manual

Installing the VersaRails Slide Assemblies

1 At the front of the rack cabinet, place a VersaRails slide assembly so that
its mounting-bracket flange fits between the marks or tape (or numbered
location) on the rack (see Figure 1-6).
The holes on the front of the mounting bracket should align with the holes
between the marks on the front vertical rail.
2 Install a 10-32 x 0.5-inch flange-head Phillips screws in the mounting
flange's top hole and the bottom hole (see Figure 1-6).
3 At the back of the cabinet, pull back on the mounting-bracket flange until
the mounting holes align with their respective holes on the back vertical
rail.
4 Install 10-32 x 0.5-inch flange-head Phillips screws in the second and third
holes (middle holes) of the back mounting flange to secure the slide
assembly to the back vertical rail.
NOTE:
cable-management arm retainer.
5 Repeat steps 1 through 4 for the slide assembly on the other side of the
rack.
NOTE:
sides of the rack.
The top and bottom flange holes will be used later for installing the
Ensure that the rails are mounted at the same vertical position on both
Dell™ Rack Installation Guide
15