Installing The Versarails Slide Assemblies; Figure - Dell PowerEdge 2650 Installation Manual

Installing the VersaRails Slide Assemblies

At the front of the rack cabinet, position one of the VersaRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape (or numbered location) on
the rack (see Figure 1-6).
The four holes on the front of the mounting bracket should align with four of the
holes between the marks you made on the front vertical rail.
Install two 10-32 x 0.5-inch flange-head Phillips screws in the mounting flange's top
2
hole and the third-from-top hole to secure the slide assembly to the front vertical rail
(see Figure 1-6).
At the back of the cabinet, pull back on the mounting-bracket flange until the
3
mounting holes align with their respective holes on the back vertical rail.
Install two 10-32 x 0.5-inch flange-head Phillips screws in the back mounting flange's
4
top and third-from-top holes to secure the slide assembly to the back vertical rail.
Repeat steps 1 through 4 for the slide assembly on the other side of the rack.
5
Ensure that the slide assemblies are mounted at the same position on the vertical rails
6
on each side of the rack.
1-10
Rack Installation Guide