Figure 1-10. Installing The Computer In The Rack - Dell PowerEdge 6400 Installation Manual

05KCEeb1.fm Page 13 Thursday, September 14, 2000 1:37 PM
5HY  ),/( /2&$7,21 5 ? ??0XOWL?9?.&(HEIP
support.dell.com
3. Tilt the front of the computer upwards while aligning the back shoulder screws
on the sides of the computer with the back slots on the slide assemblies (see
Figure 1-10).
middle latch (yellow)

Figure 1-10. Installing the Computer in the Rack

4. Engage the back shoulder screws in the slot just behind the back (green) latch
first, followed by the middle shoulder screw in the slot near the middle (yellow)
latch. Finally, engage the front shoulder screw in the front slot.
5. Push the computer inward on the slide assemblies until the middle (yellow) latch
clicks into place, locking the slide to the middle shoulder screw (see Figure 1-10).
6. Press up on the green latches and push the chassis into the rack.
7. Tighten the thumbscrews on each rack adapter bracket.
'(// &21),'(17,$/  3UHOLPLQDU\
back latch
(green)

Rack Installation Guide 1-13